I have just purchased a HAG 460 AIR14.. with LED lighting /sound...
It has a ESU V4 Loksound[M4] decoder in it..with a sugar cube speaker, attached to the LED lighting board...[Which I will replace with a 20x40 speaker]
Looking at the Function mapping...It has 5 columns: Conditions: [M4]: Physical outputs: Logical functions & Sounds:
---------------------------------------------------
So I have a HAG Skandia which I bought a LED lighting kit for, plus an ESU Loksound V4 decoder ..
This has only four columns in the function mapping.
Conditions: Physical outputs: Logical functions & Sounds : ..
So I was going to rewrite a new sound file...But what about the [M4] column ?
What is the significance of the [M4] column ?
If the data in the [M4] column is needed..how do I do it..where do I put it ?
regards
Peter Clare